Yeast Pitching & Nutrient Calculator

Underpitching is the most common cause of a slow or stuck wash: too few cells, and the yeast spends its energy multiplying instead of fermenting, while bacteria and wild yeast get a head start. This calculator works out how many cells your wash needs from its volume and gravity, then turns that into grams and sachets of dry yeast or packs of liquid yeast — and, if you pick a nutrient, the manufacturer's dosing range for your batch size.

The volume going into the fermenter.
Hydrometer reading before pitching, at 20 °C.
Dry yeast is cheaper per cell and keeps for years; liquid yeast offers far more strains.
Standard rates from White & Zainasheff: 0.75 for ales, 1.5 for lagers. Distilling washes are often pitched heavier — 1.0 is a common starting point.
Sugar washes carry almost no nitrogen, so a nutrient addition is usually needed. Dose ranges are the manufacturers' published figures.
Wort strength—
Total cells needed—
Dry yeast—
Nutrient dose—

How the numbers work

A pitch rate is a cell density per unit of sugar: so many million cells in each millilitre of wash, for each degree Plato of gravity. Multiply the rate by the volume and the gravity and you get the total cells the batch needs. The standard rates come from brewing — 0.75 million cells/mL/°Plato for ales and 1.5 for lagers, from White & Zainasheff's Yeast — and the broad rule of thumb often quoted is 1 million. Distillers usually land at the heavy end of that range or beyond it: a wash is typically stronger than a beer wort, carries less nitrogen and fewer micronutrients, and nobody is trying to coax delicate esters out of it, so pitching generously is cheap insurance against a stall. The trade-off that worries brewers — too many cells muting flavour — barely applies when the wash is headed for a still.

Dry and liquid yeast are counted differently because they are sold differently. A gram of active dry yeast holds about 20 billion living cells, so the gram figure is the cell count divided by 20 billion, and the sachet count rounds that up to whole 11.5 g sachets. Treat the gram figure as an estimate rather than gospel: manufacturers guarantee a lower minimum on their data sheets, and the real count depends on the strain, the age of the packet and how it was stored. A fresh liquid vial or smack pack holds about 100 billion cells, so the pack count is the cell count divided by 100 billion, again rounded up — and an older pack will hold fewer living cells, which is when a starter earns its keep.

Nutrient is a different kind of number. The dose ranges above come straight from the manufacturers' data sheets, and they are ranges for a reason: the right dose depends on how much nitrogen your wash already has, and a grain wash starts with far more than a sugar wash does. Whatever the dose, split it rather than dumping it all in at pitching — half near the end of the lag phase, when fermentation is just getting going, and half around one-third sugar depletion is the schedule the manufacturers recommend. DAP on its own is pure nitrogen with nothing else attached; the Fermaid blends add amino acids, vitamins and minerals, which is why they cost more and why they are the safer choice for a wash that has nothing in it but sugar and water. And remember that pitching rate only sets the starting line: how far the gravity actually falls depends on the yeast's attenuation, the share of the sugars it can ferment — the same link between OG and FG that brewers use when they pick a strain.

See also: Sugar Wash Calculator, Wash ABV Calculator, Grain Bill Calculator, Making a Yeast Starter, Water & Nutrients, Stuck Fermentations.