Vapour Speed Calculator
How hard you can drive a packed column is set by how fast the vapour moves up it. Push the power too high for the column diameter and the rising vapour holds the returning reflux liquid up instead of letting it drain back down — the column floods, the liquid level climbs, and separation collapses. This tool turns your boiler power and column diameter into a vapour velocity, and judges it against the operating band published by experienced distillers, so you can see whether a power setting is comfortable, ambitious, or asking for a flood.
The verdict below is judged against the published 20 inches per second ceiling for mesh-packed columns, with flooding reported from about 30 inches per second upward. But one distiller flooded a 2 inch column at 2200 W while another ran a packed 2 inch column at 2400 W without flooding — how tightly the packing is installed changes where the flood starts. Treat the verdict as guidance, and learn your own rig's limit by raising power slowly and watching for the liquid level climbing or the column gurgling.
How the velocity is worked out
Every watt of boiler power turns a fixed amount of liquid into vapour, set by the latent heat of vaporisation: mass flow equals power divided by latent heat. Ethanol-rich vapour needs about 945 kJ per kilogram, while steam needs about 2256 kJ per kilogram, so the same power boils off far more ethanol vapour by weight than steam. The volume that vapour occupies then follows from its density, worked out with the ideal gas law at the boiling temperature — about 1.43 kg/m³ for ethanol-rich vapour at 78 °C, and about 0.59 kg/m³ for steam at 100 °C. Dividing the volume flow by the column's cross-sectional area gives the velocity. The ideal-gas step is an approximation: it puts steam density about 2% below the published saturated-steam value, so steam velocities read about 2% high, and ethanol-rich figures are closer than that.
The verdict bands come from published hobby guidance, and the sources agree on the ceiling better than on the flood point. HomeDistiller's operating guide for VM stills puts the working band at 12 to 20 inches per second, and a StillDragon discussion quotes 20 inches per second as the most vapour speed wanted in a mesh-packed column, so 20 inches per second (0.51 m/s) is the top of the comfortable band here. Above that, separation gets worse as the vapour rushes past the packing with less time to exchange with the reflux. Flooding itself is reported from about 30 inches per second (0.76 m/s) upward in 2 inch mesh-packed columns, but the exact point moves with the packing: tightly packed mesh floods sooner, loosely packed mesh later. HomeDistiller's packed-column guidance separately recommends running at roughly 40 to 80% of the flooding velocity, which is consistent with treating 20 inches per second as a working ceiling when flooding starts near 30.
Two things are worth knowing when you use the numbers. First, velocity scales directly with power and inversely with the square of the diameter, so doubling the power doubles the speed, but going from a 2 inch column to a 3 inch one at the same power cuts the speed by more than half — widening the column is the most effective cure for a flooding rig. Second, the classic hobby setup of 1500 W in a 2 inch column works out to about 21 inches per second on this model, just over the recommended ceiling, which matches how that setup behaves in practice: it runs, and runs well, but it is at the top of its comfortable range rather than in the middle of it. Dropping to 1200 W brings the same column to about 17 inches per second, comfortably inside the band.