Column Packing Calculator

A packed column separates vapour the way a stack of plates would, and the packing is what decides how much height each plate-equivalent takes. That height is the HETP — the height equivalent to a theoretical plate — and it is the number that turns a column's packed height into an estimated plate count. This tool does that division for the packings with published HETP figures, and shows the packing volume too, so you know how much material a column needs.

The height of the packed section only, not the whole column. 100 cm = 1 m.
Use the bore, not the outside diameter — a 2 inch column measures about 51 mm across the inside.
Only packings with a published HETP figure are listed. See the notes below for what was left out and why.
Plate counts are estimates, not measurements.

HETP is not a fixed property of a packing: it shifts with vapour speed, liquid loading and reflux ratio, and with how evenly the packing is installed — a leaning column or channelling down one side can cost several plates. The ranges below are wide where the published figures disagree, and the true count for your column can only be found by running it and measuring what comes off the top. Two packings were left out for lack of a verifiable figure: generic ceramic rings have no published HETP of their own (in home columns they are ceramic Raschig rings, covered by the 6 mm entry), and marbles have only a single unverified community report behind their figure.

Packing volume (bed volume)—
HETP used—
Estimated theoretical plates—
Height : diameter ratio—

Where the HETP figures come from

The plate count is the packed height divided by the HETP, and the packing volume is the column's cross-section times the packed height — the bed volume, voids included, which is the volume of packing material the column holds. The HETP figures are the published ones, and they do not all come with the same confidence. Stainless SPP is the best supported at 2–3 cm: a still maker's guide quotes that range, a full-scale water-distillation study measured 26 mm in an 80 mm column, and a HomeDistiller discussion quotes 3 cm. Copper SPP is a different story at about 12 cm from the same maker's guide, which is why the two materials are separate options — the metal matters far more than the shape here.

For scrubbers the published figures disagree outright: one maker's guide quotes about 4 cm, while a HomeDistiller figure quotes about 10 cm, so the tool brackets the disagreement with a 4–10 cm range rather than picking a side. Copper mesh shares that range because HomeDistiller's packing data treats mesh as practically equivalent to scrubbers in hobby columns, and no published figure exists for mesh on its own. The 6 mm ceramic Raschig rings sit at 15–22 cm, from a field estimate in HomeDistiller's packing data — a 2 inch column packed with 46 inches of quarter-inch rings reaching 95% ABV — which is flagged there as a rough validation figure rather than a measured constant. An older forum figure of 24–38 cm for Raschig rings refers to larger rings and is not used for the 6 mm entry.

Height matters as much as packing choice. A metre of copper mesh gives roughly 10–25 plates on these figures, while the same metre of stainless SPP gives roughly 33–50, which is why SPP columns can be shorter for the same separation — and why a short column of Raschig rings struggles to reach high purity at all. As a rule of thumb, hobby builders aim for a packed height around twenty times the column diameter: a 2 inch column wants about a metre of packing, a 3 inch column about a metre and a half. Beyond that ratio the gains flatten out, and the column gets hard to support and keep vertical — and a column that leans lets reflux run down one wall instead of spreading through the packing, which quietly throws away the plates the height was supposed to buy.

See also: Vapour Speed, Cuts Estimator, Still Types, Distillation Techniques, Vodka.