Spirit Run Planner
A spirit run rewards a little planning: how much good spirit should this charge produce, how many jars will it take, and where should the fractions roughly fall? This tool starts from the alcohol in your boiler, applies the same fraction ranges as the Cuts Estimator, and turns them into a run plan — the hearts yield at the strength you collect at, the foreshots, heads and tails to expect, and a jar count for the day. The figures are planning estimates, not promises: your still, your wash and your palate decide the real outcome.
These are planning estimates, not cut points. Published guidance on fraction sizes disagrees widely, which is why every figure below is a range. The actual cuts are made during the run — by smell, taste and alcoholmeter readings, judged jar by jar — not by any calculator. If a jar is borderline, keep it apart: it can always be blended back in later, but a jar blended too early cannot be taken out again.
How the plan is built
The plan begins with the pure alcohol in the boiler: charge volume times ABV, scaled by the recovery figure to give the alcohol you can realistically collect. The hearts portion of that alcohol — 25–70%, the same range the Cuts Estimator uses — is then turned into a volume of spirit at your collection strength: divide the hearts alcohol by the strength, so 2 litres of hearts alcohol collected at 65% ABV fills about 3.1 litres of jars. Foreshots are sized at 2–6 mL for every litre of wash, and a low-wines charge is traced back to the wash it was stripped from, because low wines carry the foreshots of every wash that went into them. Heads (5–30%) and tails (10–35%) are shown as shares of the collectable alcohol, exactly as in the Cuts Estimator — they are alcohol figures, so the volumes coming off the still will be larger than the alcohol alone.
The collection strength matters because hearts do not come off the still at a fixed proof. On a pot still they start near 80% and slide down through the cut, reaching 60–65% by the time most distillers move into tails; the Scotch middle cut traditionally runs from about 72% down to 65%. The 65% default is a typical average across the cut, and you should set it to whatever your own runs average — a reflux still, which holds a steadier and higher strength, will want a higher figure. Because the yield is the hearts alcohol divided by this strength, a lower collection strength means more litres in the jars for the same alcohol, and a higher one means fewer.
The jar counts are the practical payoff. The hearts figure divides the hearts yield by your jar size and rounds up at each end of the range, so it tells you how many jars the keep will need. The whole-run figure is rougher: it adds up the midpoints of all four fractions, converting heads at an assumed 80% ABV and tails at an assumed 25%, then divides by the jar size. Those two assumed strengths are planning judgements, not measurements — heads run at about 80% and above on a pot still, and tails are collected from roughly 40% down towards 10% — so treat the total as a guide and line up a few spare jars. A jar you do not use costs nothing; running out of clean jars mid-run costs you a cut decision made in a hurry.
Like the Cuts Estimator, this planner keeps the ranges wide on purpose: the published guides disagree with one another by a wide margin, so the four fractions' low ends come in under the collectable alcohol while their high ends come in over it. That bracketing is deliberate — it sketches the shape of the run rather than pretending to an exact split. Use it to set out your jars and to know roughly when to start paying close attention, then make the real cuts by nose, taste and readings, jar by jar.