Strip Run Planner

A stripping run is about speed, not finesse: get the alcohol out of the wash into low wines for a later spirit run. This planner tells you how much low wines to expect, and — just as important — how much liquid will be left in the boiler, so you don't run the element dry.

Volume in the boiler at the start of the run.
Strength of the wash, from your hydrometer readings.
Average strength of everything you collect. For a 10% wash, 25–35% is typical — lower if you run deep into the tails.
Share of the wash alcohol you expect to collect. 90% is realistic; the last few percent isn't worth chasing.
The volume that must stay in the boiler to keep your heating element covered. Measure it on your own still — 0 to skip the check.
Pure alcohol in the wash—
Expected low wines—
Left in the boiler—
Element stays covered?—
First-drops strength—
Wash boiling point (sea level)—

How it works

The maths. Low-wines volume = (wash volume × wash ABV ÷ 100 × recovery) ÷ low-wines ABV × 100. The boiler loses roughly the collected volume, so what stays behind is the wash volume minus the low wines. Both are estimates: the boiler loses a little extra to evaporation and to the water that comes over with the tails, and contraction shaves a little off the collected volume.

Choosing the low-wines strength. The first drips come off strong (about 55% from a 10% wash) and weaken as the run goes on. Where you stop decides the average: stopping early gives strong, small-volume low wines; running deep gives more volume at a lower average strength, with more tails character. For a spirit run later, most distillers strip to an average of about 25–30%.

Never expose a heating element. An electric element above the liquid line will overheat, scorch, and can fail or start a fire. Know your still's minimum charge volume and stop collecting before you reach it — the last litre of low wines is never worth a ruined element or a dangerous run.

See also: Pot Still Yield, Boiling Point Calculator, Pure Alcohol & Bottle Count.