Boiler Charge Planner
Most charges are not a single liquid: a spirit run blends low wines with the feints saved from earlier runs and tops up with water, and a stripping run can take feints the same way. This tool works out how much wash, feints and water to combine to hit the volume and strength you want. You fix the feints share — how much of the charge is feints — and the tool solves for the rest. If the mix cannot be made, it tells you why and what to change, instead of handing you a negative volume.
Above about 40% ABV the charge itself is flammable, so a leak or a spill near a heat source can ignite the liquid in the boiler, not just the vapour. The standard safety guidance is to keep every boiler charge at or below 40% ABV — some guides put the ceiling lower, at 35%. If your low wines or feints are stronger than that, dilute them with water first. The tool will warn you if the target goes above 40%.
How the mix is solved
The tool is an alcohol balance — the same Pearson's square reasoning blenders have used for generations, done in three steps. First it fixes the feints, because you chose their share: feints volume is the target volume times the feints share. Then it works out how much alcohol the finished charge must hold (target volume × target ABV) and subtracts the alcohol the feints already bring; the remainder has to come from the wash, so the wash volume is that remainder divided by the wash strength. Whatever volume is left over after the feints and the wash is water. With the default figures — 25 litres at 15% from 10% wash and 50% feints at a 20% share — the feints are 5 litres holding 2.5 litres of alcohol, the charge needs 3.75 litres of alcohol in total, so the wash must supply 1.25 litres, which is 12.5 litres at 10%, leaving 7.5 litres of water.
Two mixes cannot be made, and the tool names the problem instead of failing silently. If the feints alone hold more alcohol than the whole target charge needs, no amount of wash or water can bring the strength back down — the only fixes are a smaller feints share or a higher target. And if the wash is too weak, even filling every remaining litre with wash leaves the charge short of the target — then the fixes are a bigger feints share, stronger feints, or a lower target. A target above the strength of both the wash and the feints is the same problem in disguise: water can only dilute, so the target has to sit within reach of what you are mixing.
Two approximations sit behind the numbers. The first is that volumes are treated as additive — a litre of spirit plus a litre of water is taken as two litres of mix. In reality ethanol and water contract slightly when mixed, by about 3% of the volume at 40% ABV, so the finished charge comes out a touch under the target volume and a touch over the target ABV. For a boiler charge that is a small error, but it is why the page shows a resulting-ABV check and why you should confirm the charge with an alcoholmeter before you run. The second is that the tool takes your ABV figures at face value: measure the wash and the feints rather than guessing them, since a feints jar you think is 50% and is really 40% throws the whole mix off.
Feints deserve a word of their own. They are the heads and tails you set aside instead of drinking — full of flavour compounds, some pleasant and some harsh — and adding them back into the next charge recovers their alcohol and carries their character forward. That is standard practice in Scotch whisky distilling, where foreshots and feints go back into the next spirit charge, but it is worth remembering that feints also carry the compounds you cut away for a reason. Keep the share modest, keep foreshots out of the feints jar entirely (they are discarded, never recycled), and if a run's feints smell wrong, leave them out.