Fermentation Time Estimator
Every wash answers the same question — when will it be ready to run? — and no calendar gives a clean answer, because yeast is alive: it works faster warm than cold, faster on a light wash than a heavy one, and not at all once the alcohol around it passes what it can survive. This tool turns your yeast type, your wash temperature and your original gravity into a planning range for the days until the gravity stops falling, and it flags the two ways a ferment goes wrong before it starts: a temperature outside the yeast's range, and a sugar load that would push the alcohol past the yeast's tolerance. The answer is a range on purpose — a ferment that lands anywhere inside it is behaving normally, and the hydrometer, not the calendar, is what tells you it is done.
Fermentation time is not a formula with one right answer — it shifts with the pitch rate, the nutrients in the wash, how well it was aerated, and the health of the yeast, none of which this tool can see. The ranges below are planning figures built from published fermentation times and manufacturer charts; a healthy ferment can land outside them and still be fine, and the only reliable test for "done" is a hydrometer reading that stays put for a day or two.
How the estimate is worked out
Every yeast type starts from a published base range — the days it typically takes to reach final gravity at a stated gravity and in the middle of its temperature range. A distiller's yeast at a wash gravity of 1.060 is put at 3–5 days, baker's yeast at the same gravity at 4–7, an ale yeast at beer gravity (1.050) at 5–10, a wine yeast at wine gravity (1.090) at 7–14, a lager yeast at beer gravity at 10–21, and a turbo yeast at wash gravity at 1–2. Those starting points come from brewing and winemaking references and from manufacturer charts, and each one is quoted at the gravity its source actually describes, so the tool is not pretending a wine timeline was measured on a beer-strength wash. The full list of sources is in FORMULAS.md.
Two adjustments then move the range. The gravity adjustment scales with the square of the sugar load: doubling the sugar in the wash roughly quadruples the time, because the yeast has twice as much to eat and the alcohol it produces slows it down as the level rises. That squared relationship is calibrated against the Still Spirits turbo chart, which gives 2 days at 30 °C for a 14.5% wash and 5 days at 25 °C for a 20% wash — after allowing for the temperature difference, the time ratio matches a squared sugar ratio, and three of the four published points on that chart fall inside the ranges this tool produces. The temperature adjustment works at about 6% per degree: each degree above the middle of the yeast's range shortens the ferment by roughly 6%, each degree below it lengthens it by the same. That figure sits between the two pairs of points on the Still Spirits chart (about 3% and 8% per degree) and the baking rule of thumb that yeast activity rises about 10% per degree — it is a judgement call, and it is the softest number in the model.
What the model does not account for matters as much as what it does. Pitch rate is the biggest gap: a heavy pitch finishes sooner than a light one, and an underpitched wash can take days longer or stall outright. Nutrients are next — a sugar wash with no nitrogen starves the yeast however warm it is — followed by aeration at the start, the age and storage of the yeast, and pH, which can crash in a sugar wash and stop a ferment cold. The temperature you enter is also assumed to hold steady for the whole ferment; a wash pitched warm that chills overnight will take longer than the range suggests, and the range makes no allowance for the ferment warming itself a few degrees during the most vigorous days. Take the output as a planning window for when to start checking the gravity, not as a date to book the still for — and if the wash is past the yeast's alcohol tolerance, no amount of waiting will finish it: that is what the tolerance check is for.