
Tomato-Paste Sugar Wash (Birdwatchers Style)
The most widely made sugar wash in home distilling: cheap, forgiving, and dependable. A jar of tomato paste gives plain sugar water the nutrients yeast needs to ferment cleanly to dryness, and the result is a neutral wash that is ideal for a first distillation — including the sacrificial cleaning run on a new still.
Before you start: read the Safety guide first. Fermentation itself is low-risk, but everything this wash is destined for involves flammable vapour, high temperatures, and — in many places — legal restrictions; the Legality guide explains the legal picture. This recipe assumes you already know how to read a hydrometer and keep a fermenter clean.
The recipe began as a 2007 forum post by a distiller known only as “Birdwatchers” (or “G”), and it has been made, argued over, and refined by thousands of home distillers ever since. Its trick is the tomato paste: ordinary table sugar dissolved in water has almost nothing in it for yeast to live on, so the paste supplies the nitrogen and nutrients the yeast needs. The quantities below are scaled to a 25 L (6.6 gal) batch from the original 80 L recipe, and cross-checked against the recipe table built from that original.
Ingredients
- 5 kg white sugar
- 200 g tomato paste
- Juice of 1 lemon (or about 1 teaspoon of citric acid)
- A pinch of Epsom salts (magnesium sulfate)
- 80 g dried bakers yeast
- Water to make up the batch volume
Method
- Warm about half the water in a large pot and stir in most of the sugar until it dissolves. Pour the syrup into your fermenter and add the rest of the water.
- Stir in the tomato paste until there are no lumps left — dissolving it in a little hot water first makes this much easier. Add the lemon juice (or citric acid) and the pinch of Epsom salts, and mix well.
- Take a hydrometer reading. You are aiming for a starting gravity between 1.060 and 1.090; most makers aim below 1.070, because a gentler starting gravity means less stressed yeast and fewer off-flavours. If the reading is low, stir in a little more sugar; if it is high, add a little more water.
- Let the wash cool to between 26 °C and 30 °C (79–86 °F). Sprinkle the yeast evenly over the surface and stir it in if you like — many makers simply leave it on top.
- Cover the fermenter loosely so carbon dioxide can escape while insects and dust stay out, or fit an airlock. Keep it warm and steady, ideally in that same 26–30 °C range.
- After 5–14 days the bubbling will slow and stop, and the gravity should read around 0.990. Give it a few more days to settle — a week if you can — so the solids drop out before you distil.
- Rack the cleared wash off the sediment into your boiler, leaving the yeast cake behind. Solids in the boiler can scorch, and scorched yeast throws burnt flavours into the spirit.
Expected results
A wash starting near 1.070 and finishing near 0.990 comes out at roughly 10% alcohol by volume — the published recipe table puts a 1.070-to-0.990 wash at 10.32% ABV. A 25 L batch at that strength holds about 2.5 L of pure alcohol, of which a careful run through a reflux still will recover roughly 2 L as high-strength spirit once foreshots, heads, and tails are set aside. Through a pot still the same wash gives a lower-strength, more flavourful result, and is normally stripped first and then run a second time. Use the wash ABV calculator with your own gravity readings rather than trusting these round numbers.
In short: starting gravity 1.060–1.090 (aim below 1.070), final gravity around 0.990, about 10% ABV, and roughly 2 L of spirit from a 25 L batch.
Tips
- Do not be tempted to push the sugar higher. A starting gravity above 1.090 stresses bakers yeast, risks a stuck fermentation, and produces harsher spirit. More sugar does not mean more good alcohol.
- The tomato paste will look alarming. It curdles and floats, and the wash smells cidery. That is normal, and none of it carries into the distillate.
- Temperature matters more than the calendar. In a cool room the same wash can take the full two weeks; in a warm one it may finish in five days. The hydrometer tells you when it is done, not the date.
- Let chlorinated water breathe first. Chlorine in tap water can be driven off by leaving the water to stand uncovered for a day or two before you mix the wash; chloramine needs a charcoal filter or campden tablets instead.
- Dissolved gas keeps bubbling after fermentation ends. Carbon dioxide coming out of solution can make an airlock bubble for days after the yeast has finished. Trust the hydrometer — a stable reading over two days means it is done.
Sources
- Birdwatchers, “Birdwatchers sugar wash recipe” (original 2007 recipe, 80 L) — ingredients, SG target of 1.09, 30–35 °C fermentation, 7–8 days to 0.995. homedistiller.org
- Audeamus Distilling, “How To: Tomato Paste Wash” — recipe table scaled from the original; SG range 1.060–1.090; pitch at 26–30 °C; SG 1.070 to 0.990 gives about 10.32% ABV; chlorine and chloramine handling; racking to avoid scorching. audeamusdistilling.com
- HomeDistiller forum, Birdwatchers recipe discussion — 4 kg sugar in a 23 L ferment at SG 1.069 finishing near 0.990 for 10.25% ABV; procedure of mixing 80% of water and sugar, then adjusting SG. homedistiller.org