
Cereal Wash — Cornflakes Whiskey
Cornflakes whiskey — CFW to its makers — is bourbon made from breakfast cereal. The flakes bring corn flavour and a useful dose of B vitamins for the yeast, the sugar brings the alcohol, and the whole thing comes from a supermarket shelf. It is one of the easiest whiskeys a beginner can make, and it runs for generations on backset like any sour mash.
Before you start: read the Safety guide first. Fermentation itself is low-risk, but distilling the result involves flammable vapour, high temperatures, and legal restrictions in many places — see the Legality guide.
The recipe comes from the Aussie Distiller forum, where Zak Griffin published it as a "Tried and Proven" recipe after adapting an earlier cornflakes whiskey by a distiller known as Odin. Griffin's original makes 40–45 litres in a 50-litre fermenter; the quantities below are scaled to a 25-litre batch and cross-checked against the smaller batches makers in the thread actually run. The idea is disarmingly simple: breakfast cereal is already-cooked grain, so there is no mashing to do — the flakes just need crushing and a short boil to turn them into a porridge the yeast can work with. Griffin chose the recipe precisely because he had no feed store or homebrew shop nearby, only a supermarket, and the result surprised him: at a barbecue, his white cornflakes whiskey was finished before anyone had touched the bottle of commercial bourbon beside it.
Why cereal works
A plain sugar wash ferments poorly on its own because refined sugar contains almost nothing a yeast cell needs beyond energy — no nitrogen, no vitamins, no minerals. That is why sugar washes usually need a nutrient source, whether tomato paste, bran, or a commercial nutrient. Cornflakes are a convenient one: they are made from corn, so they carry the flavour of the grain the whiskey is meant to taste of, and the vitamin-enriched flakes most supermarkets sell bring B vitamins that keep the yeast healthy. The flakes also give the wash body and a little extra fermentable starch. They are not, on their own, a rich nutrient source — makers who have compared cereals find cornflakes carry roughly a third of the nutrients of bran flakes, which is why the sibling recipe, Rad's All Bran wash, ferments faster on the same sugar load — but with a generous yeast pitch and a week of patience, cornflakes do the job well.
Ingredients
Makers disagree a little on how many flakes a batch wants: the original recipe measures them by volume (2 litres of whole flakes for 40–45 L), while makers running 25-litre batches use 375–500 g — about one box. The recipe is forgiving, and the amount mainly changes how corny the result tastes, so the range below covers both. Use plain, unflavoured cornflakes, not frosted or flavoured varieties.
- 375–500 g plain cornflakes (about one box)
- 4 kg white sugar
- 2 tbsp lemon juice (or the juice of 1 lemon)
- 2–3 tbsp dried baker's yeast
- Water to make up the batch volume
Method
First generation
- Crush the cornflakes — in a bag with a rolling pin, or briefly in a blender — until they are broken down to small pieces or crumbs. Whole flakes swell and can block a siphon later, so this step is worth doing properly.
- Bring about 6 L of water to the boil in a large pot, stir in the crushed flakes, and cook them for a few minutes until you have a thick yellow porridge. Tip the hot porridge into the fermenter.
- Bring another 6 L of water to the boil, stir the sugar into it until it has dissolved, and pour the syrup into the fermenter. Stir in the lemon juice, then top up with cold water to the full batch volume.
- Let the wash cool to 25–30 °C (77–86 °F). Take a hydrometer reading — you should see a starting gravity near 1.065 — then pitch the yeast, give the wash a good stir to mix in some air, and fit the airlock.
- Leave it to ferment for about a week, then leave it a further two days to settle clear so the solids drop out. The wash is done when the bubbling has stopped and the gravity has settled near its finished reading.
- Rack the clear wash into your still, straining it through a stocking or fine cloth to catch any chunky bits. Leave the yeast and grain bed in the fermenter. Scoop out a litre or so of the spent grain, and add cool water to cover the bed so the yeast stays alive while you run the still.
Running it and the next generations
- Strip the wash hard and fast through a pot still, collecting the low wines down to about 20% ABV. A 25-litre wash gives roughly 4–5 litres of low wines. Set them aside, and save 4–6 litres of backset from the boiler — no more than about a quarter of the batch volume.
- For the next generation, crush about 200 g of fresh cornflakes into the hot backset and cook for about 5 minutes until it thickens to porridge, then add it to the fermenter. Dissolve a fresh 4 kg of sugar in boiling water, add it, and top up with water to the full batch volume.
- Check the temperature is back in the 25–30 °C range before the mixture meets the yeast bed — hot backset poured straight onto the yeast will kill it, and the original recipe's author learned that one the hard way. Give it a good stir and fit the airlock.
- The surviving yeast bed should start working again within a few hours. If there is no sign of life after 12 hours, sprinkle in another spoonful or two of fresh yeast, stir, and it should be bubbling within the hour.
- Keep stripping generation after generation. Once you have stripped four or five generations, you will have enough low wines to dilute to 40% ABV and run one slow, careful spirit run — that is where the whiskey is made.
Expected results
A 25-litre batch with 4 kg of sugar starts at a gravity of about 1.065 — the figure reported for a 23-litre batch in the original thread — and finishes near 0.990, giving a wash of roughly 9–10% ABV. A full batch holds about 2.3 L of pure alcohol, which a stripping run concentrates into roughly 4–5 litres of low wines; those are saved up across generations for a spirit run, so a single generation on its own yields only a modest amount of finished whiskey. Fermentation takes about a week at a warm room temperature, plus a couple of days for the wash to clear. Lower starting gravities give a slightly less alcoholic wash with more concentrated corn flavour, and several makers in the thread prefer it that way — if your gravity comes in nearer 1.060 than 1.065, that is a feature, not a failure. Check your own readings with the wash ABV calculator.
Tips
- Crush the flakes well. Whole or barely broken flakes swell in the wash and will clog a racking cane or siphon. Break them down to crumbs before they go anywhere near water.
- Watch the pH on later generations. Backset is acidic, and the pH falls a little further with each generation. Bakers yeast is happiest around pH 5–5.5; makers in the thread find a teaspoon of bicarbonate of soda in a 25-litre wash raises the pH by about half a point, and cheap pH strips are enough to keep track.
- Keep backset to a quarter of the batch. About 4–6 litres in a 25-litre fermenter is the usual ceiling — enough to carry the sour-mash character forward without souring the wash past what the yeast can handle.
- Try the All Bran variation. Rad's All Bran wash is the sibling recipe: bran flakes carry roughly three times the nutrients of cornflakes, so a half-and-half mix of bran flakes and cornflakes ferments faster and still tastes of corn. Odin's original cornflakes recipe, by contrast, uses more flakes (2.5 kg per 100 L, about 625 g at this size) and boils them with a quarter of the yeast in backset for 30 minutes.
- Age it on oak. The spirit is drinkable white as a mixer, but the recipe's author calls it delicious after eight weeks on toasted oak — and a charred stick adds colour as well as flavour.
Sources
- Zak Griffin, “Cornflakes Whiskey (CFW)” (Tried and Proven), Aussie Distiller — 40–45 L batch: 2 L whole cornflakes, juice of 2 medium lemons, 7 kg sugar, 4–5 tbsp baker's yeast; flakes boiled to a porridge, sugar dissolved in boiling water, pitched at 25–30 °C; ferments in about a week plus two days to clear; strip hard and fast collecting 7–8 L low wines down to 20%; later generations use 1 L flakes, 7–8 L backset, 7 kg sugar; spirit run after 4–5 generations of low wines diluted to 40%; eight weeks on toasted oak. aussiedistiller.com.au
- Aussie Distiller forum, CFW chat thread — 23 L batch: 375 g cornflakes, 2 tbsp lemon juice, 4 kg sugar, 2.5 tbsp yeast, starting gravity 1.065; 450–500 g of cornflakes as the rule of thumb for a 25 L wash; no more than 25% backset (6 L in a 25 L fermenter); 1 tsp bicarbonate of soda raises the pH of a 25 L wash by about 0.5; yeast happiest at pH 5–5.2. aussiedistiller.com.au
- Hefezelle, Tried And True Recipe Book (2018), chapter 10, “Odin's Cornflakes Whiskey”, and chapter 9, “Rad's All Bran & Rad's Gerber” — Odin's version (per 100 L) uses 17.5 kg of sugar and 2.5 kg of B-vitamin cornflakes, with 100 g of yeast and 25 L of backset, fermenting in about 5 days; Rad's All Bran (per 100 L) uses 18 kg of sugar with 5 kg of All Bran cereal and 1.5 quarts of fresh bakers yeast, done after 7 days. scribd.com
- HomeDistiller forum, “All Bran Recipe” discussion — cornflakes carry roughly a third of the nutrients of bran flakes; crush all flaked material finely, since whole flakes will clog a racking cane; backset adds flavour with each generation. homedistiller.org